A. Since IPv6 address's are 128-bit and hence four times longer than
an IPv4 address, addresses are expressed as:
X:X:X:X:X:X:X:X
where each X is a 4-digit hexadecimal integer (16 bits) and each digit is 4
bits and so can be between 0 and F (F is 15 in hexadecimal) and so examples of
valid addresses would be
FEDC:BA98:7654:3210:FEDC:BA98:7654:3210
1080:0:0:0:8:800:200C:417A
Notice in the second address you can leave off any leading zeros, but you
must have at least one numeral in each part. For example :0800: can be written
as :800:.
Obviously you may have a large sequence of zero's in the address and so it
is possible to have a single gap by writing :: which will fill the gap with
zero's, for example
1080:0:0:0:8:800:200C:417A
may be written as
1080::8:800:200C:417A
0:0:0:0:0:0:0:1 the loopback address (the same as 127.0.0.1 in IPv4) can be written as ::1.
A third format is available, when dealing with a mixed environment of IPv4
and IPv6 nodes is
x:x:x:x:x:x:d.d.d.d
where the 'x's are the hexadecimal values of the six high-order 16-bit
pieces of the address, and the 'd's are the decimal values of the four
low-order 8-bit pieces of the address (standard IPv4 representation). Examples:
0:0:0:0:0:0:13.1.68.3
0:0:0:0:0:FFFF:129.144.52.38
or in compressed form:
::13.1.68.3
::FFFF:129.144.52.38
The subnet mask is now replaced by a number appended to the network address
specifying the number of bits making up the network part (CIDR notation), e.g.
ipv6-address/prefix-length:
12AB:0000:0000:CD30:0000:0000:0000:0000/60
12AB:0000:0000:CD30::/60
Means the first 60 bits make up the network part of the address.
When writing both a node address and a prefix of that node address (e.g.,
the node's subnet prefix), the two can combined as follows:
the node address 11AC:0:0:CA20:123:4567:89AB:CDEF
and its subnet number 11AC:0:0:CA20::/60
can be abbreviated as 11AC:0:0:CA20:123:4567:89AB:CDEF/60
Register
